Table of Contents
Lgnition Switch Warning Indicator Light
When you start the vehicle, the instrument panel will light up an indicator light. Don’t worry, this means that all the subsystems of the vehicle are self-checking.
If the self-checking is completed, these indicator lights will go out. General hazard warning, some important function failure, this function does not have a corresponding special warning light, you need to determine the faulty part according to the maintenance manual.
1. The meaning of the lgnition switch warning indicator light:
The lgnition switch warning indicator light is usually caused by the poor fuel combustion in the engine cylinder. In automobile design, in order to ensure that the engine is in good working condition and the normal working life of the engine, an oxygen sensor is designed and installed on the engine to monitor the combustion state of the engine.
2. What happens when the lgnition switch warning indicator light turns red?
The lgnition switch warning indicator light is an indicator light for the working state of the engine, which is used to display the working state of the vehicle engine.
When the key door is opened, the lgnition switch warning indicator light is turned on after the power is turned on. During the vehicle self-checking, the lgnition switch warning indicator light is turned on for about 3-4 seconds and then goes out automatically, indicating that the engine is working normally.
If the lgnition switch warning indicator light does not turn on or stays on, it means that the engine has a mechanical failure and needs to be overhauled in time.
3. Is it safe to drive with the lgnition switch warning indicator light on?
In either case, you should check the car. It may indicate a problem with the ignition switch, or a problem with the key used.
The problem with the ignition switch is usually a mechanical problem, it will prevent the key from turning you can try to clean the keyhole, but the switch may need to be replaced, or even the key may need to be replaced to solve the problem. If this light is on when you are driving, it may be the reason why the key can be verified again.
The indicator lights on cars generally have the following colors: red, yellow, green, blue, and white. These colors have the same meaning as the various levels of warning in our lives, indicating different degrees of severity.
Red: hazard indicator, stop immediately, the vehicle has major safety hazards.
Yellow: fault indicator, you can drive to the repair station with caution, the vehicle is faulty.
Blue: High beam indicator, indicating that the high beam is on.
Green: Function indicator, does not affect driving, indicate the working status of a certain device or needs to perform a certain operation.
White: The function indicator light generally indicates that the functions that are not related to driving are in the on the state, such as the air conditioner is on, the wind mode, the rear window heating, etc.
If there is any indicator of light demand or customized indicator light, we will design and produce it in a very short time, such as the lgnition switch warning indicator light. Please don’t hesitate to write us an email at [email protected]
Brand-New Introduction Of 64 Dashboard Indicator Light
Click to view the video introduction of dashboard indicator light